Source addresses and DTC descriptions are presented in plain text. Suspect parameter number (SPN), failure mode indicator (FMI) and occurrence count numbers are listed. The VID can be used to display all diagnostic trouble codes (DTC) on the vehicle. Displaying Codes on the VID (if equipped) NOTE – Turning the key switch off, turning the key switch to the CRANK position, or releasing the park brake will take the gauge cluster out of the diagnostic mode. The following information will be displayed for each fault: To manually cycle through the fault list press and release the cluster display selector button. Once all faults have been displayed the number of faults will be displayed again, then the cycle will repeat. If faults are present, the gauge cluster display will show each diagnostic trouble code for 10 seconds and then automatically scroll to the next entry and continue to cycle through the faults. NOTE – The gauge cluster will only display “Software Rev” and “Hardware Rev” for 5 seconds followed by the message “Diagnostic Trouble Codes are not available” if the vehicle is not equipped with the option to display codes. The gauge cluster will then display the following information for 5 seconds: Momentarily press the Cruise “ON” switch and the Cruise “Resume” switch at the same time.Ī gauge sweep will be performed on the gauges.Turn the key switch to the IGNITION position to view both active and previously active codes. Turn the key switch to the ACCESSORY position to view only previously active codes.To display codes on vehicles not equipped with a VID: VEHICLES EQUIPPED WITH OPTION TO DISPLAY CODES Displaying Codes on the Gauge Cluster (Non-VID equipped vehicles)
0 kommentar(er)
